Assembly and wiring of our black twin inline foot switch

This is a quick step-by-step guide on how to assemble and wire our black twin inline foot switch.

In this example, i will be showing you how to wire this twin switch using 1x feed and 2x outputs.

Any electrical work should be carried out by a competent person.

This switch comes in pieces and consists of the following items:

  1. Back Switch Body
  2. Front Switch Body
  3. Body Screws
  4. Neutral Block
  5. Switches
  6. Switch Covers

 

Step 1: Take the neutral block and place it into the centre of the switch body.

 

Step 2: Wire the switches as show below. This configuration of wiring is 1 feed and 2x outputs, you can have 2 separate feed and 2 output if you wish.

Feed is the bottom cable and the 2x outputs are the 2 cable at the top.

 

Step 3: Once wired, and you are happy with the connections and configurations, place the switch caps onto of the switches.

Step 4: Once the caps are resting on top, carefully place the top cover over the top, note the cover will only go one way as the switches are off-centre slightly.

Step 5: Finally, flip the unit over and place and tighten the 2x cover screw into position.

This now concludes the step-by-step guide, hopefully this has helped assemble and understand how to the wire switch.

Please get in touch if you still have any questions.

Was this article helpful?
0 out of 0 found this helpful

Comments

0 comments

Please sign in to leave a comment.